- Opening : Mon-Fri 08:00 - 17:00
Product
Category TX PLUG-IN SERIES
Tag Power: 12.500W
TX12.5K PLUG-IN CA
PLUG-IN system 12.500W.
The image of this layout is purely demonstrative and may change without notice. The configuration is only referred to installed equipment; rack, cover panels and all others accessories are to be defined at order.
Features
> Hot-pluggable and broadband power amplifier modules.
> Each module features switching mode power supply to control and stabilize power supply voltage.
> Each amplifier module provides Automatic Power Control.
> Suitable for mono & stereo broadcast operations.
> Protection against high VSWR, overdrive, overcurrent and overtemperature.
> Compliance to IEC safety standards.
> Compliance to ETSI – CCIR – FCC standards.
> Entire transmitter can be switched off through an emergency button.
> High redundancy guaranteed by 3 power modules of 2.2 kW RF power.
> All measurement and working parameters are displayed on front panel.
> Remotely controllable by telemetry system.
> Design for 24/7 non-stop operation.
> The transmitter include an integrated system for automatic and manual switching between two exciters.
In Automatic mode the changeover is activated when active power of exciter falls below 3dB.
TX12.5KSS/60D41 | ||
Parameter | ||
GENERALS | ||
Frequency Range | 87,5 – 108 MHz | |
Rated output power | 12.5kW + 10% | |
Driver power for rated output | 30W | |
VSWR | 1.4:1 with automatic fold-back at higher VSWR | |
Asynchronous AM S/N Ratio | Typically >70dB | |
Synchronous AM S/N Ratio | Typically > 55dB | |
Harmonics suppression and Spurious | Typically < 85dB | |
RF Harmonics | Exceeds ETSI/CCIR/FCC requirements | |
RF Spurious | Exceeds ETSI/CCIR/FCC requirements | |
Environmental working conditions | -10° to +50° C / 95% relative Humidity non condensing | |
POWER REQUIREMENTS | ||
AC Power Inuput | AC Supply Voltage | 400V ± 10% AC Three-Phase 3F+N 230V ± 10% AC Three-Phase 3F+N 230V ± 10%AC Mono-Phase 50/60 Hz |
ActivePower Consumption | About 17.7 kW | |
Power factor | > 0.95 | |
Overall Efficiency | 70% | |
Connector | Terminal Block Standard | |
MECHANICAL DIMENSIONS | ||
Phisical Dimensions | L x H x W | 685 mm x 1935 mm x 1000 mm |
Weight | About 380 kg | |
Cooling | Forced with internal fan | |
Acoustic Noise | < 75 dBA | |
OUTPUTS | ||
RF Output | 50 Ohm (1+5/8” EIA flange type) |